完成步骤1到4，确保没有轴向负载施加在连杆上。

单选题完成步骤1到4，确保没有轴向负载施加在连杆上。

A、 Finish stage 1 to 4 to ensure that no axial force is derived from the rod.

B、 Do steps 1 thru 4 to make sure that no axial load is applied on the rod.

C、 Procedures 1 to 4 are designed to check if the rod exerts axial force.

由4l***d5提供分享举报纠错

相关试题

单选题当拉动下部轴承时，可以看到下部的封圈。

A、The lower seal is invisible prior to switching the lower bearing on.

B、The lower seal becomes visible when you push the lower bearing up.

C、The lower seal comes into view when you pull the lower bearing down.

单选题在这种配置中，液压会旁通此阀门。

A、The valve allows the hydraulic pressure to pass through in this configuration.

B、The hydraulic pressure is blocked by the valve in this setup.

C、In this configuration, the hydraulic pressure bypasses the valve.

单选题关于如何在恶劣天气下停放的说明，请参阅第6章。

A、The instructions for taxing in bad weather conditions are found in chapter 6.

B、Chapter 6 provides instructions on pulling up in normal weather conditions.

C、Refer to chapter 6 for instructions on how to park in bad weather conditions.

单选题系统接口电路应能够适配连接系统的物理特性。

A、The system interface circuits control the physical properties of the connected systems.

B、The system interface circuits adapt to the physical properties of the connected systems.

C、The physical configuration of the connected systems defies the behavior of the system interface circuits.

单选题确保卡箍位置与拆卸过程中记录的位置保持一致。

A、Make sure that the position of the clamp agrees with the position that you recorded during the removal procedure.

B、Confirm that the recorded condition during the removal procedure agrees with the condition of the clamp.

C、Ensure that the clamp is correctly oriented based on the suggested position documented during the removal procedure.

单选题确保襟翼收回，并且使副翼配平手轮处于零位。

A、Make sure that the flaps are retracted and the aileron trim handwheel is in the zero position.

B、Ensure that the flaps are partially extended and the aileron trim handwheel is centered at zero.

C、Make sure that the flaps are raised and the aileron trim handwheel is set to non-zero position.

单选题移除所有的防止操纵面自由运动的校装销和设备。

A、Take out all the rigging pins and equipment that promote free motion of the control surfaces.

B、Remove all the rigging pins and equipment that prevent free movement of the control surfaces.

C、Clear the control surfaces from any rigging pins and equipment that contributes to their unrestricted mobility.

单选题为了快速拔掉销子，手动将盖子向一个方向转动，然后再向另一个方向转动。

A、Turn the canopy manually clockwise to make the pin removal process easier.

B、To make pin removal easier, manually turn the canopy in one direction and then in the other.

C、Rotate the canopy in one direction and then in the other to hinder the removal of the pin.